TechSpot

Barton 2500+ on a A7N8X-X is dead

By W|ckerMan
Dec 5, 2003
  1. Hi i was building up my new system yesterday and most of it went fine. I succeded to start the computer, went into the bios to look at the cpu temp, to be secure the fan was connected as it should and working proberbly.
    But i saw that i had connecter the cpufan to the chassis fan connector so i turned of the computer and connected it to the cpu fan connector were it should be. Now the computer do not start.
    Sometimes without beepes and other times with 1 long and 2 short beepes.

    I have tried different memory and AGP card but nothing help. and in the manual it does not say what the beepes mean.

    :confused:

    Anybody know what may cause this problems?
     
  2. Didou

    Didou Bowtie extraordinair! Posts: 4,274

    When you installed the CPU fan to the CHA_FAN1 connector, did you not get an error message saying no RPM detected for the CPU fan ?

    Is connecting the CPU fan to the CPU_FAN the only modification you did ?

    Try holding down the INSERT key while powering on the machine, if that doesn't work try a clear CMOS ( follow instructions in the manual ).
     
Topic Status:
Not open for further replies.

Similar Topics

Add New Comment

You need to be a member to leave a comment. Join thousands of tech enthusiasts and participate.
TechSpot Account You may also...