also @ TechSpot: Leaked next generation iPhone casing photos validate multiple rumors

TechSpot
Collaborate in the cloud with Office, Exchange, SharePoint, and Lync.
Microsoft Office 365. Pay-as-you-go starting at $8/user/month. Begin your free trial now.

Beryl, ATi Catalyst stopped working after system updates

Discussion in 'The Alternative OS' started by i_am_a_newbie, Apr 9, 2007.

Thread Status:
Not open for further replies.

  1. i_am_a_newbie Newcomer, in training

    Using Fedora Core 6, and I had beryl effects working properly and the ATI catalyst control center was functioning properly as well.

    However, I allowed the system to update itself (231 updates or so) and afterwards, ATI CC fails to even load, Beryl loads but the effects are no longer working. I'm still new to Linux so troubleshooting is a huge pain so far...

    Any help would be appreciated, thanks.
    i_am_a_newbie, Apr 9, 2007
    #1

  2. Nodsu Newcomer, in training

    You probably updated your kernel and you have to reinstall/recompile the ATI drivers.
    Nodsu, Apr 9, 2007
    #2

  3. i_am_a_newbie Newcomer, in training

    Actually... I have figured out it had nothing to do with the updates..

    When I initially installed the ATI drivers, for some reason, ATI CC hadn't been fully installed yet, so when I rebooted it completed the installation and caused Beryl to stop working.

    Now I just need to figure out how to uninstall the ATI CC (I tried looking on the ATI website but it only tells me how to uninstall earlier versions that used the Fire-GL interface). Thanks again.
    i_am_a_newbie, Apr 9, 2007
    #3
Thread Status:
Not open for further replies.