1. TechSpot is dedicated to computer enthusiasts and power users. Ask a question and give support. Join the community here.
    TechSpot is dedicated to computer enthusiasts and power users.
    Ask a question and give support.
    Join the community here, it only takes a minute.
    Dismiss Notice

Cannot start setup

By Dexnewb
Jun 22, 2011
Post New Reply
  1. I wanted to install a program and when I clicked on the setup file, this came up "Only part of a ReadProcessMemory or WriteProcessMemory request was completed". What can the causes be, and are there any solutions to this problem?
     
  2. Mark56

    Mark56 TechSpot Paladin Posts: 1,889

    Found this solution on another forum, hope it helps.

    Go into your device manager->IDE ATA/ATAPI controllers. Right click on secondary and choose properties. Go to the advanced settings tab and choose PIO only for "transfer mode". I would ensure that your drive is connected to the secondary controller first though.
     

Similar Topics

Add New Comment

You need to be a member to leave a comment. Join thousands of tech enthusiasts and participate.
TechSpot Account You may also...