computer could not start after bios post and hung

By rakeshupadh
Jan 29, 2007
  1. i just recently buit by own comupter by the purchase mother board chintech borad, 2.8 mhz intel processor,128 agp geforce card and 256 ddr, 40 gb hardisk, but i have problem is my comuter coudn't start, i check my all cable and all thing i purchaed new but when computer start dedect harddisk and when boot from cd that time system is hang's every time same problem i could not understand what is problem, pls help me about this matter and will be highly appriciated

    system config
    p4 chintech borad
    intel 2.8 mhz processor
    128 agp geforce
    256 ddr
    40 gm harddisk
    dvd combo

  2. gavinseabrook

    gavinseabrook TS Rookie Posts: 320

    Did you set your jumper on the harddrive and dvdcombo? if so see if cable select works. Does it detect in BIOS?
  3. rakeshupadh

    rakeshupadh TS Rookie Topic Starter

    hi friends,

    jumper is set harddrive both dvd and drive and board is detected in BIOS, i have change ram also however still same problem, pls help about this matter

  4. gavinseabrook

    gavinseabrook TS Rookie Posts: 320

    Try to do a flash on your bios and reconfigure.
  5. rakeshupadh

    rakeshupadh TS Rookie Topic Starter

    hi problem has been sloved , i have reconnect all part its something processor fan not fit properly therefore its problem appear now system working properly
    thanks for give me reply of my thread.

  6. green1977

    green1977 TS Rookie

    I put a playstation2 game CD into my laptop(fujitsu siemens) and suddenly my computer shutt off itself there is an attention on the screen every time(NT dedect) how can i solve that problem?
Topic Status:
Not open for further replies.

Similar Topics

Add New Comment

You need to be a member to leave a comment. Join thousands of tech enthusiasts and participate.
TechSpot Account You may also...