TechSpot

Configuring router for CS:S

By beef_jerky4104
Jun 29, 2007
  1. I've need to configure my router so I can run a CS:S server on it.

    I have opened up the correct ports on the router but people could not connect. I then disabled the built in NAT firewall and that allowed people to join the server. However after I disabled it other computers on my network could not connect to the internet. Wired or wireless.

    How could I fix this.
     
  2. raybay

    raybay TS Evangelist Posts: 7,241   +9

    Reset everything by pressing the reset button on the back, clean the registry, then reinstall using the supplied disc. Secure the system with WPA, and follow the manual carefully. Also, check for firmware upgrades from the manufacturers web site.
     
  3. beef_jerky4104

    beef_jerky4104 Banned Topic Starter Posts: 822

    I have done this and everything is back to normal.

    Now, how can I set the router up for a CS:S Server?
     
  4. raybay

    raybay TS Evangelist Posts: 7,241   +9

    Yup. You should have no trouble
     
  5. beef_jerky4104

    beef_jerky4104 Banned Topic Starter Posts: 822

    Strange because the NAT firewall blocks peope from joining my server and as soon as I disable it everyone else on the network can't connect.
     
Topic Status:
Not open for further replies.

Similar Topics

Add New Comment

You need to be a member to leave a comment. Join thousands of tech enthusiasts and participate.
TechSpot Account You may also...