D-link wireless router

[santiago8821]

I have a wireless D-LINK DSL-G604T. How can i change the IP address for WAN? I am using PPP0E as my connection. Thanks

 

[Nodsu]

You don't.

Your ISP assigns you an IP when you establish a PPPoE connection. Whether you get a fixed one or it is reassigned every time, depends on your ISP and your service.

 

[Samstoned]

do a dhcp release renew if you have a router check under status
wait awhile you may get a new WAN
you can do this a coupla times depends on yout isp pool for you area

to do under cmd window
run ,cmd in this window go to c:\ (root)
type ipconfig /release the ipconfig /renew
looks like this c:\ipconfig /release note the space between fig and /

 

[DelJo63]

I have a wireless D-LINK DSL-G604T. How can i change the IP address for WAN? I am using PPP0E as my connection. Thanks

response above are correct, but WHY do you think you NEED to change it?

 

[santiago8821]

halo.. i want to change to ip addres because there r two ip address to connect to... One is the faster, the other one is so much slower.. so i am trying to change my wan ip address to the faster one..

 

[DelJo63]

halo.. i want to change to ip addres because there r two ip address to connect to... One is the faster, the other one is so much slower.. so i am trying to change my wan ip address to the faster one..

hum; I think you're confuse with the IP address vs the NIC card(s).
By definition, an IP address has no speed; that's an attribute of a NIC card.
if you have multiple NICs in the machine (say a 10mb and a 10/100mb),
then just wire into the one you want to use.

 

[santiago8821]

okay thankx thankx.. hehe