One error is 0x8E and these are almost always caused by hardware and are especially strong indicators of corrupted memory.
0x00000050: PAGE_FAULT_IN_NONPAGED_AREA
Requested data was not in memory. An invalid system memory address was referenced. Defective memory (including main memory, L2 RAM cache, video RAM) or incompatible software (including remote control and antivirus software) might cause this Stop message, as may other hardware problems (e.g., incorrect SCSI termination or a flawed PCI card).
Unfortunately all five errors only list a Vista driver as the probable cause and OS drivers are usually too general to be of much help.
However, with your error codes in light of persistent BSODs this points to corrupted memory. To determine if this is the case you will need to run Memtest on your RAM.
See the link below and follow the instructions. There is a newer version than is listed but either one should work. If you need to see what the Memtest screen looks like go to reply #21. The third screen is the Memtest screen.
Let it run for a
LONG time. The rule is a
minimum of 7 Passes; the more Passes after 7 so much the better. There are 8 individual tests
per Pass. Many people will start this test before going to bed and check it the next day.
If you have errors you have corrupted memory and it needs to be replaced.
Also, with errors you need to run this test per stick of RAM. Take out one and run the test. Then take that one out and put the other in and run the test. If you start getting errors before 7 Passes you know that stick is corrupted and you don’t need to run the test any further on that stick.
Link:
https://www.techspot.com/vb/topic62524.html
* Get back to us with the results.
