also @ TechSpot: Facebook headhunts Apple engineers for 3rd smartphone attempt

TechSpot

New to overclocking, ran into problem

Discussion in 'Overclocking, Cooling and Modding' started by k1n9k00p4, May 11, 2006.

Thread Status:
Not open for further replies.

  1. k1n9k00p4 Newcomer, in training

    I tried overclocking my brothers computer so i just put the FSB from 100 to 135 but now when i turn the computer on the monitor wont come on, the light is just flashing also, no optical mouse light comes on neither do any keyboard lights and the HDD light at the frot is constantly flashing.

    What can i do to sort this out?
    k1n9k00p4, May 11, 2006
    #1

  2. howard_hopkinso Newcomer, in training

    Turn off the computer and unplug it from the mains.

    Open the case and take out the cmos battery for a few minutes. Replace the cmos battery, this will reset the bios to the default settings. Hopefully the computer should boot ok. You may need to enter the bios in order to reset some things after.

    Regards Howard :)
    howard_hopkinso, May 11, 2006
    #2

  3. CMH TechSpot Chancellor

    If you didn't increase the voltage, you shouldn't need to worry about it too much.
    CMH, May 12, 2006
    #3
Thread Status:
Not open for further replies.