No picture when monitor is plugged into eMachines on-board graphics port

By Kazzz
May 2, 2006
  1. i installed a rage 128 video card and i want to go back to my original on-board video but whenever i plug my monitor in it, i get a black a screen..does anyone have an idea on how to fix it?
  2. kirock

    kirock TS Rookie Posts: 1,221

    You probably need to enable on-brd graphics again in the BIOS. Plug monitor bk into rage card reboot, press DEL key to enter BIOS. It will be the Standard CMOS set-up or the PCI/Plug n Play menu.
  3. Kazzz

    Kazzz TS Rookie Topic Starter

    i dunnooo

    what if i install the drivers for my old video card? then uninstall my agp
  4. N3051M

    N3051M TS Evangelist Posts: 2,115

    you will still need to tell the pc to use the onboard and not the agp -hardware wise. drivers are software for windows to run it so getting to bios to swithc onboard should be non probs.. just do what kirock said
Topic Status:
Not open for further replies.

Similar Topics

Add New Comment

You need to be a member to leave a comment. Join thousands of tech enthusiasts and participate.
TechSpot Account You may also...