also @ TechSpot: Apple CEO declines $75 million payout in stock dividends

TechSpot

no temperature showing

Discussion in 'Overclocking, Cooling and Modding' started by bobaraba, Feb 23, 2005.

Thread Status:
Not open for further replies.

  1. bobaraba Newcomer, in training

    i downloaded speedfan and everest hopme to check my temperature.. it shows up fine on my other pc but this one just shows blank where the temp should be. does it mean there are no sensors on this board? its an older pentium3 815eea. or is there a way to enable it
    bobaraba, Feb 23, 2005
    #1

  2. fishhookz Newcomer, in training

    I don't think that kind of software will work with every board. A hardware front panel would be a solution. With speed control. Not expensive. But then again, I don't think it'd be worth it to monitor a P3 or older PC.
    fishhookz, Feb 24, 2005
    #2

  3. bobaraba Newcomer, in training

    temp.

    yea your right. i was just curious why it didn't register with everest home. i don't do anything with the pent 3 anyway but surf the web etc. temp. shows up fine on my other pc which is newer. thanks
    bobaraba, Feb 24, 2005
    #3

  4. howard_hopkinso Newcomer, in training

    You could always try Motherboard monitor(mbm5) you can get it HERE

    Regards Howard :)
    howard_hopkinso, Feb 25, 2005
    #4
Thread Status:
Not open for further replies.