TechSpot

Problems reinstalling my Radeon 9200 driver

By jimflint1
Jun 10, 2005
  1. I finally found the disk. But when I go to set up, I get this message:

    Setup was unable to complete the installation.Try to set up you display adaptor with a standar VGA driver before running setup.

    The questions are, how do I do this, and do I need to? Or what else could I do to get that driver loaded?

    Shane
     
  2. howard_hopkinso

    howard_hopkinso TS Rookie Posts: 24,177   +19

    First download Driver cleaner from HERE. Go to your add remove programmes, and uninstall any ATI entries. Read the instructions, then run the cab cleaner first, followed by driver cleaner. Now reboot your system.

    After you have finished, go HERE and download and install the latest drivers for your card.

    Regards Howard :D
     
  3. jimflint1

    jimflint1 TS Enthusiast Topic Starter Posts: 212

    Hi Howard,

    I tried your suggestions, but I'm still getting the same error message. Any other ideas?

    Thanks,

    Shane
     
Topic Status:
Not open for further replies.

Similar Topics

Add New Comment

You need to be a member to leave a comment. Join thousands of tech enthusiasts and participate.
TechSpot Account You may also...