Trouble Booting

[NVK101]

Hi, I'm having trouble booting my computer. It's an old comp intel pentium 4 processor 3.0 ghz socket 775 and its mother board is Gigabyte GA-8IP775-G. I put in a new 500 gb SATA hard drive and whenever I boot it up I get to the Ubuntu Lynux install page and my computer just shuts down. I was running the power supply through my very old computer and it worked fine. The power supply is 350 Watt. Also there is 4 gb ram dual channel. Thank you to whoever posts.

 

[BlkHeartWolf]

did you set the bios correctly

On-chip SATA
Disabled Disable SATA controller.
Auto When there is no device to be plugged in IDE1 or IDE2, SATA controller
will remap to IDE controller. (Default value)
Manual Set SATA Mode manually.
SATA Port0 Configure as
IDE Pri. Master Remap SATA Port 0 to IDE Pri. Master.
IDE Pri. Slave Remap SATA Port 0 to IDE Pri. Slave.
IDE Sec. Master Remap SATA Port 0 to IDE Sec. Master.
IDE Sec. Slave Remap SATA Port 0 to IDE Sec. Slave.
SATA Port0 SATA controller set to SATA port0. As this mode, it support by WinXP or
later OS only. (Default value)
SATA Port1 SATA controller set to SATA port1. As this mode, it support by WinXP or
later OS only.
SATA Port1 Configure as
The values depend on SATA Port0.
USB Controller

 

[NVK101]

Ok, now when I went into the bios settings my computer shut off while I was in the middle of it.

 

[BlkHeartWolf]

power problem maybe connect SATA to a single output no other drices attatched

 

[NVK101]

I think its my fan. Its most likely my fan. Is there any way for me to make sure its my fan

 

[NVK101]

Yep it was my cpu fan.