TechSpot

Video/post problems

By dkemp
Jul 21, 2006
  1. I have installed a Pentium D 930 on an Intel DIO@GGc2 MB. I have added an ATI X800XL PCI-E video card. I have reseated the processor, video card, and memory (2G of DDR2) and still get no post/video. Any suggestions?
     
  2. nickslick74

    nickslick74 TS Rookie Posts: 575

    Do you get a beep code or is there an LED on the Mobo that could flash a trouble code?
     
  3. dkemp

    dkemp TS Rookie Topic Starter

    Video/post problems cont

    I don't get a beep code of any kind. It is very frustrating. I have not see any kind of flash code.
     
  4. nickslick74

    nickslick74 TS Rookie Posts: 575

    Do the fans start up?
     
  5. dkemp

    dkemp TS Rookie Topic Starter

    The fans run great.
     
  6. Tedster

    Tedster Techspot old timer..... Posts: 6,000   +15

  7. Kevin16

    Kevin16 TS Rookie Posts: 92

    Has your computer ever been able to start up since you built it?
     
  8. dkemp

    dkemp TS Rookie Topic Starter

    This is a fresh build. Hasn't started yet.
     
  9. Kevin16

    Kevin16 TS Rookie Posts: 92

    Ok most new motherboards use a 24-pin power connector. If you only have a 20-pin one, then your computer won't boot. Check to see if you attached the separate 4-pin connector.
     
  10. dkemp

    dkemp TS Rookie Topic Starter

    The power connector is ok, with the 20 and 2x2 connected. I have tried a different monitor, switched out the DDRs and still get no video and no beep codes. The fans run like crazy. I am running out of ideas
     
Topic Status:
Not open for further replies.

Similar Topics

Add New Comment

You need to be a member to leave a comment. Join thousands of tech enthusiasts and participate.
TechSpot Account You may also...