HP Officejet t45 / t45xi / t65 / t65xi All-in-One Driver 1.2 for Win 2000

September 11, 2004
oj452en.exe
30.4 MB
Windows 2000
7,855
NOTE: Due to the size of the download and the time it would take, HP recommends ordering the CD-ROM version rather than downloading the Web version of the driver without broadband (Cable, DSL, T1, or equivalent) Internet access. To order the full release CD, with all software features, use the "Back" button to display the previous page and select the software beginning with CD.

ECP Mode Must be ON! (Extended Capabilities Port)
If you plan to connect your HP OfficeJet or HP Printer/Scanner/Copier to your PC via the PC's parallel port, your computer's parallel port must be set to ECP mode to operate properly under Windows 2000. ECP mode allows greater I/O (communications) capabilities through your parallel port and is enabled via the computer's BIOS. Restart your PC, and in most cases, you will be prompted to hit F1, F2, or DEL to Enter your computer's BIOS or "Setup" program. (Check your PC's documentation or vendor's web site for more info).

Once you have entered SETUP, locate the configuration section for your PARALLEL PORT and modify it to read ECP. If ECP is not a choice, use a variation of ECP, such as ECP & EPP, or ECP DMA1. Save changes and reboot. Windows 2000 should recognize this and list the Item ECP Printer port in the Device Manager of the Control Panel/System applet under "Ports". If your PC does not support ECP, it will likely fall below the minimum system requirements for Windows 2000. It is also recommended that you install Microsoft Service Pack 1 for Windows 2000. Please visit Microsoft's web site, www.windowsupdate for more information.

Manual Installation Instructions:

After you save the file to your hard drive, follow the installation/deinstallation instructions for assistance.
Alternative drivers to HP Officejet t45 / t45xi / t65 / t65xi All-in-One Driver 1.2 for Win 2000: