Hi, I happened to have an old motherboard lying around, so I decided to make a computer out of it. The problem that arose was that I attached a 12v molex connector to two wires with another connector which leads to these pins that usually you would attach the case power and HDD Light and Power Light. When I did this I booted up and the board would not start. I know I did something wrong, that I fed it 12v, and possibly might have fired it. Any clue to how I could get it running again???
Here is the .pdf for the motherboard manual http://www.solorb.com/gsale/p2bf-103.pdf
Here is the .pdf for the motherboard manual http://www.solorb.com/gsale/p2bf-103.pdf
