Have spent hours getting to a point where I can print wirelessly only by rebooting the laptop and then printing one document. Further prints fail - unless laptop rebooted. The print server is connected wirelessly to a Dlink DSL-G604T modem/router. I reckon that, since the print server WLAN light is flickering intermittently the whole time - even when the machine is switched off - that the print is not completed properly and that the print server does not receive a print end instruction. This is borne out also after rebooting and printing that only 99% of the print job is performed - it never gets to 100%. Has anyone else seen this problem - and has anyone fixed it? Otherwise the print server will be going back to the store.