Cannot configure router

By Vandy
May 7, 2007
  1. I'm wanting to enable DHCP on my router, but when I type in the default gateway I get a page with absolutely nothing on it. When I type in other IP's I get a "cannot load page" message, but when I type the gateway (that I found through ipconfig/all in the command prompt), nothing happens, just a blank white page.

    Anybody know what the problem is?
  2. raybay

    raybay TS Evangelist Posts: 7,241   +10

    Try pressing the reset button with the paperclip through the hole in the back or bottom of the router. You might also want to download and install the latest firmware from the manufacturers website.
  3. Nodsu

    Nodsu TS Rookie Posts: 5,837   +6

    Yes, I would guess the router has crashed. Before doing a possible factory reset with the paperclip, try unplugging and re-plugging the router first.
Topic Status:
Not open for further replies.

Similar Topics

Add your comment to this article

You need to be a member to leave a comment. Join thousands of tech enthusiasts and participate.
TechSpot Account You may also...