Wireless Router Hook Up

Status
Not open for further replies.
Hello all

I'm not sure that I am in the correct screen, if not I'm sorry but this is my first time in this site and I am learning. Anyway I have a wireless laptop and a wireless-G 2.4 GHz broadband router and I am haiving a fit hooking it up to my wired computer. I am following the instructions on how to wire it to my computer but I lose my connection to my wired computer everytime. If some one could let me know what I am doing wrong that would be great. Thanks a lot for reading this and hopefully for some help.

Kenny
Baltimore Md.
 
Router: Turn on, check for correct lights on/off/blinking etc.
Connect an Ethernet cable from LAN port 1 to your PC.
Connect an ethernet cable from the WAN port to your modem.

PC: Turn on. Go to Network Connections, right click Local Area Connections>Properites
select [Internet Protocol (TCP/IP)] and click on [Properties]
Select [oObtain an IP address Automaticaly] [ok] [ok]

Proceed to setup your router etc.
 
2 diff config's for dsl and cable
if cable set as dynamic automatic address
if dsl set to pppoe
set to keep alive
enter your user name and password
if verizon ,user name is main email account
you cannot have the wireless and wired connection on same time in same machine
I just did a home system with d-link wireless G
sorry I did not keep the manual
if need be to reset and start over
 
Status
Not open for further replies.
Back