TechSpot

Likom Monitor Model : L7052NP - width unadjustable

By foxboy
Dec 27, 2006
  1. Hello all:)

    I have a problem with my monitor Likom model: L7052.. cannot adjust the horizontal... what possible part's have defect?

    any help appreciated.

    tnx in advance.
     
  2. Tmagic650

    Tmagic650 TS Ambassador Posts: 17,244   +234

    Make sure you are not over or under stressing the monitor. The horizontal frequency may either be too high or too low. Try setting the video refresh rates to different settings and see if the horizontal width becomes adjustable...
     
  3. foxboy

    foxboy TS Rookie Topic Starter

    Yes, i set it in normal size..(800x600)... vertical, brightness, contrast... etc.. function properly.. except the horizontal (width).. it increase and decrease the percentage when you push the horizontal button but it no effects on display.

    i think it has a defective parts... anyone can send me the schematic diagram of LIKOM L7052NP...

    thnx
     
  4. Tmagic650

    Tmagic650 TS Ambassador Posts: 17,244   +234

    You will probably find a burnt resistor around or near the flyback transformer. Check for cold solder joints in this area too. I repaired CRT monitors from 9 to 42 inches in size, from 1989 to 1999
     
Topic Status:
Not open for further replies.

Similar Topics

Add New Comment

You need to be a member to leave a comment. Join thousands of tech enthusiasts and participate.
TechSpot Account You may also...