TechSpot

No signal from 6800 after mod

By Chad Fm
Jun 3, 2006
  1. // Removed
     
  2. CrossFire851

    CrossFire851 TS Rookie Posts: 766

    Have you tried resetting the jumpers or removing the cmos battery?? The cmos battery looks like a little coin. Remove it for about ten minutes and reinsert it and it will put BIOS back to factory defaults and hardware.

    Just push the tab down holding the battery.
     
  3. Chad Fm

    Chad Fm TS Rookie Topic Starter

    I tried resetting the cmos using the reset jumper, but I suppose I will try removing the battery.

    Thanks.
     
  4. kangaruffian

    kangaruffian TS Rookie Posts: 175

    Might have that burn something else when u soldering it back :( (pcb has multiply layers)
     
  5. CrossFire851

    CrossFire851 TS Rookie Posts: 766

    I missed the part about the ic falling off. That gotta suck because it voids all warranty moding the fan.
     
  6. Chad Fm

    Chad Fm TS Rookie Topic Starter

    Yeah, I don't think there's much I can do but buy a new one.
    Thanks.
     
Topic Status:
Not open for further replies.

Similar Topics

Add New Comment

You need to be a member to leave a comment. Join thousands of tech enthusiasts and participate.
TechSpot Account You may also...