Read on full site | Join TechSpot! (it's free) | Bookmark / Share this



Tutorial: No POST (Power On Self Test)

kimsland
09-29-2008, 10:52 PM
Tutorial: No POST (updated)

----------------------------------------------------------------------------------------------------------------------
Power On Self Test

The BIOS determines if the video card or onboard video is working.
The BIOS verifies RAM.
It checks for a keyboard and mouse.
It looks for a PCI bus and then checks the cards that are installed.
The system information is then displayed on the screen.

POST (http://en.wikipedia.org/wiki/Power-on_self-test) is determined by the computer's BIOS (http://en.wikipedia.org/wiki/BIOS) (Basic Input/Output System)
User settings are made in CMOS (http://en.wikipedia.org/wiki/CMOS) (complementary metal oxide semiconductor)
----------------------------------------------------------------------------------------------------------------------



Fault: Computer will not start

Fix: See below


Disperse internal Voltage

Remove all power (adapter power Cord and Battery (for laptops))
Hold down the ON button for 30secs (dispersing internal voltage)
Plug the power cord in only (ie leave battery out, for the moment)
Turn on

Did it work?
If so, shutdown normally, and fit the battery back in (for laptops)
Continue on as per normal

If not, try removing all externally connected devices, leaving in Power; Video; and Keyboard only
(even test without Keyboard and mouse plugged in)


Reset CMOS

Many No POST failures are caused by your computer's CMOS settings being corrupt
Resetting the CMOS to defaults will cure this, and possibly allow your computer to POST
By reading your computer's or motherboard's Manual (discussed further down this page)
Locate the CMOS battery and/or the "reset CMOS jumper" on your motherboard
Following the reset CMOS procedure (usually shorting two pins, with CMOS battery out)
Your CMOS settings will be reset, hopefully allowing your computer to startup (or POST)


Hardware issues

Firstly it's always best to download your computer, or motherboard, manual
You can locate your manual, by going to you manufacturer's support page
For convenience (and as an example) Here is Dell's (http://www.techspot.com/vb/topic100658.html) and HP's (http://www.techspot.com/vb/topic100655.html) support info
Make sure to follow all AntiStatic and power recommendations/precautions

On PCs: (ie not laptops)

Re seat the Ram card(s)
Reconnect all internal connections
All drive data cables can even be fully unplugged
Re seat or remove, all addon PCI cards
Unplug the case fan

Or try Benchtesting (http://www.techsupportforum.com/1010960-post1.html) the motherboard

On Laptops:

Please note, it is also a good measure to re seat the Ram card(s) and also the Harddrive for laptops
You may need to locate your disassembly guide, at Google (http://www.google.com/ncr), not all manufactures provide this guide.
As an example, here is a good Toshiba laptop disassemble (http://www.irisvista.com/tech/) guide


Removing Dust

Dust and debris, is usually the biggest factor on computers that will not start
Using High compressed air, or a vacuum cleaner, remove all dust from the computer
With special attention on all Fans; the CPU; the Ram; and the Power Supply Unit
Here's an excellent guide to clean your computer (http://mikescomputerinfo.com/cleancomputer.htm)


Power Supplies

Note: Although this subject has been discussed in the "Benchtesting" link above,
Just because some lights come on, does not mean your Power Supply is working properly.

It is also possible that your actual power switch is faulty
Or even the Display off micro button is faulty, (on laptops (http://www.techspot.com/vb/topic55208.html))

In most cases, it's a matter of testing with a known working Power Supply
Here's an excellent link (http://www.bfgtech.com/bfgpower/faq.html) on Power Supply information and troubleshooting



Some more helpful links

Read the original No Post Tutorial (http://www.techspot.com/vb/topic53866.html)

Beep Codes (http://www.techspot.com/vb/topic95391.html)
Ultimate Boot CD (http://www.techspot.com/vb/topic123957.html)
Reseating your CPU (http://www.arcticsilver.com/arctic_silver_instructions.htm)
An excellent Flowchart (http://www.fonerbooks.com/poster.pdf)
Windows Repair Guide (http://www.windowsreinstall.com/)
Manufacture Drivers (http://www.techspot.com/vb/topic117607.html)
Drive Diagnostics (http://www.techspot.com/vb/topic7602.html)
Memtest (http://www.techspot.com/vb/post653029-21.html)


If you still require support with No POST, please create a New Thread (http://www.techspot.com/vb/topic114336.html)
Stating what you have tried (or reply to your own existing related thread)
Making sure that you put System Specs (http://www.majorgeeks.com/EVEREST_Ultimate_Edition_d4876.html) information in your Profile (http://www.techspot.com/vb/profile.php?do=editprofile#system)
.

Post a reply, see related topics & more

Tip: Download Advanced SystemCare 3 Free - Clean, Repair, Protect & Optimize your PC.



 Top Technology News

TechSpot Blog: Disable Windows automatic check for solutions after a program crashes

Weekend Open Forum: Google Chrome OS and the future of cloud computing

Tech Tip of the Week: Unearth Region-Specific Windows 7 Themes

Weekend tech reading: How to run Chrome OS as virtual machine

Sony: PlayStation 3 to be 3D-capable via firmware update

iSuppli: DDR3 to account for over half of DRAM shipments by Q2 2010

Facebook named third most popular video website behind YouTube and Hulu

Patriot introduces new PS-100 SSD series

More Tech News

  
 Software Downloads

Norton Virus Definitions 2003-07 November 20, 2009

AVG Anti-Virus Updates November 20, 2009

Norton Virus Definitions 2008-09 November 20, 2009

avast! Virus Definitions November 20, 2009

McAfee SuperDAT Update 5808

Kaspersky Anti-Virus Update November 20, 2009

Google SketchUp 7.1.6087

More Downloads



Copyright © 1998-2009 TechSpot.com. TechSpot is a registered trademark. All Rights Reserved.