XP & ICHR10 Drivers - Can I Go RAID/SATA F6 After Install?

I would like to run my hard drive in RAID single disk mode. I installed XP with the MB set to Enhanced IDE mode, so I never "F6"'d the drivers during the install.

Can I turn back the hands of time? Or must I do a clean install of XP? My eventual goal would be a second drive in RAID 0, but single disk for now.

Thanks for any info.

IMHO, if it was that easy, there would be no need for the F6 procedure to begin with. You'll have to start over I believe. For a single disk you should set the BIOS to AHCI mode.