So you set Check Disk to fix the faults I hope?
Here's my guide on that: (make sure you read the part in red)
Please try this:
Manual steps to run Chkdsk from My Computer or Windows Explorer- Open My Computer, and then right-click the hard disk that you want to check.
- Click Properties, and then click Tools.
- Under Error-checking, click Check Now. A dialog box that shows the Check disk options is displayed
Use one of the following procedures:
- • To run Chkdsk in read-only mode, click Start.
- • To repair errors without scanning the volume for bad sectors, select the Automatically fix file system errors check box, and then click Start. (tick)
- • To repair errors, locate bad sectors, and recover readable information, select the Scan for and attempt recovery of bad sectors check box.
Note If one or more of the files on the hard disk are open, you will receive the following message:
Quote:
|
The disk check could not be performed because the disk check utility needs exclusive access to some Windows files on the disk. These files can be accessed by restarting Windows. Do you want to schedule the disk check to occur the next time you restart the computer?
|
Click
Yes to schedule the disk check, and then
restart your computer to start the disk check.
Wait until Chkdsk finishes Checking / Repairing any faults
Windows will then either restart your computer or continue loading Normally.
05-17-2008, 01:28 AM
Similar Threads
