Configuring two routers

[essen]

I have 2 wireless routers. one is Netgear Wgr614 v9 with brodband internet connection which is configured by service provider with following configuration.

ip: 122.252.224.106
subnet mask : 255.255.255.0
gate way :122.252.224.1

dns :203.153.47.251
alt dns : 203.153.41.28

second one Netgear:Wnr 834B v2 is connected to vsat to use my office software with below configuration
ip: 10.116.80.2
subnet mask : 255.255.255.224
gate way :10.116.80.1

dns :202.54.149.115
alt dns : 202.54.149.113

now i am unable to accecess both at same time, pl give me configuration details to accecess both routers at same time

 

[brucethetech]

if u are referring to the web config this is no surprise. if you pull up the other router you session will have to be reautheticated over and over as you pop back and forth btw the web configs. they may even cross over (you log in and theres the config page for the other router.) this will be way off if u werent talking about connecting to the router via web config. please elaborate if you were or not

 

[DelJo63]

chaining routers can be a challenge, but the SIMPLE way is

modem----(wan)Router#1(lan)-----(lan)Router#2(lan)--- other systems

Notice, the wan port on router#2 is left EMPTY. It needs to have DHCP disabled,
so that Router#1 provides the DHCP service.

Disconnect the two router, connect one computer to router#2
Login to the config page using the default router address,
Disable DHCP and save the config.

Now rewire as above and you're good to go