IC7-G conflicts with ATI 9550

By lpmjames
Jun 18, 2010
  1. so i have recently pieced together an ic7-g motherboard and decided to go with an ati raedon 9550 graphics card but it will not allow me to load .. i get the load screen then when it gets to login screen my screen goes blank.. i can get it going in safe mode no problem. but why wont it load otherwise... is it a software conflict and should i just load the card with only the drivers and not the hydravision utilities.. ?? help please this is very frustrating.
  2. Tmagic650

    Tmagic650 TS Ambassador Posts: 17,244   +234

    Get into the motherboards bios and set the first video device to AGP. It's too bad ABit is out of business... I liked there products. Your IC7-G was made in 2002-3
  3. lpmjames

    lpmjames TS Rookie Topic Starter Posts: 148

    ok yea.. i know that.. and the problem has since been corrected.. i dont know what i did .. but its fine now.. .. 2nd im having a wireless networking issue.. should i start a new thread
  4. Tmagic650

    Tmagic650 TS Ambassador Posts: 17,244   +234

    Yes, start the new thread in General Hardware
Topic Status:
Not open for further replies.

Similar Topics

Add New Comment

You need to be a member to leave a comment. Join thousands of tech enthusiasts and participate.
TechSpot Account You may also...