TechSpot

Ipaq Connection Point CP-2W Router

By Ringrs
Aug 1, 2005
Topic Status:
Not open for further replies.
  1. I have the above quoted router and have recently connected a new modem to the router. I used the installation disk that came with the modem which is for the ISP Telstra Bigpond. When installing the modem and using this CD my IP address for the router has been altered/reconfigured. It was 198.162.1.1. When I try using this IP address to log onto my router, as I have done in the past, I get a message back advising it cannot connect. I know I can reset the router back to its default settings but I would like to avoid this if possible. How do I detect what the new router address is to log into the router. The ip address for the modem is 10.0.0.138 and each of my PCs attached to the router are 10.0.0.1, .2, ,3 etc. Any assistance greatly appreciated.
    Cheers
    Steve
Topic Status:
Not open for further replies.


Add New Comment

TechSpot Members
Login or sign up for free,
it takes about 30 seconds.
You may also...


Get complete access to the TechSpot community. Join thousands of technology enthusiasts that contribute and share knowledge in our forum. Get a private inbox, upload your own photo gallery and more.