TechSpot

Lan setup configuration

By marygg
Mar 17, 2010
  1. Need to reinstall a network using a HughesNet 2wire modem, a Dlink router and a Linksys router. If the 2wire is 192.168.0.1, what are the ip addresses for the Dlink, Linksys and computer? The Linksys is supposed to be a range extender. Can someone help? I appreciate it.
     
  2. hughva

    hughva TS Rookie Posts: 58

    Why two routers?
    What are you trying to accomplish?
    What models?
     
  3. jobeard

    jobeard TS Ambassador Posts: 9,317   +618

    I'll give you this layout; you copy/paste and correct it as appropriate:)

    Code:
    modem---router#1 ---(wired or wireless) --- router#2
               |                                   |
               V                                   V
               systems                         Wired, wifi or both
               connect
               Wired, wifi or both
    
    
     
  4. Annyyu22

    Annyyu22 TS Rookie

    why are you trying to accomplish?
     
  5. marygg

    marygg TS Booster Topic Starter Posts: 121

    This was a connect issue. It had been set up to send signal through a long house including a brick wall. The 2wire had been replaced. It never crossed my mind that the dlink router had also failed. New router, problem solved. Thank you so much for your help.
     
Topic Status:
Not open for further replies.

Similar Topics

Add New Comment

You need to be a member to leave a comment. Join thousands of tech enthusiasts and participate.
TechSpot Account You may also...