joshuamays
Posts: 137 +0
So yeah, i have a Lanparty UT nF3 250GB Mobo. Not 100% on what goes goes where. Unable to locate a users manual online. The wires are as follows:
4pin white / open / black / red with the same 4pin connection on the other side
(Qty. 2) 4pin red VCC / white USB2- / green USB2+ / black GND with a separate 1pin GND
2pin red / white -> H.D.D. LED
2pin orange / white -> POWER SW
2pin blue / white -> RESET SW
Welcome to how to wire your mobo 101. Really need some help figuring out where these go. Thx
4pin white / open / black / red with the same 4pin connection on the other side
(Qty. 2) 4pin red VCC / white USB2- / green USB2+ / black GND with a separate 1pin GND
2pin red / white -> H.D.D. LED
2pin orange / white -> POWER SW
2pin blue / white -> RESET SW
Welcome to how to wire your mobo 101. Really need some help figuring out where these go. Thx