No Signal

By bubble
Aug 29, 2008
  1. Hello, is there way to change my resolution while in safe mode, and have the resolution that i changed start working when i turn on my computer normally. I have this problem that when I turn on my computer normally it says No SIgnal, but when i turn it on in safe mode the resolution changes to 800 600, and there is no problem with the picture. Sooo umm is there a way to change my settings while in safe mode and have those settings go in effect when i turn on my computer normally?

  2. SNGX1275

    SNGX1275 TS Forces Special Posts: 10,714   +397

    Hit F8 before windows loads, like what you are doing to get into safe mode. Then choose VGA mode. Once in there its like normal Windows, just at 800x600 or something, you can change to whatever you want then and it will stick.
Topic Status:
Not open for further replies.

Similar Topics

Add New Comment

You need to be a member to leave a comment. Join thousands of tech enthusiasts and participate.
TechSpot Account You may also...