TechSpot

pls check my modding for possible short circuits

By truflip
Dec 11, 2005
  1. well i dont think u can check.. but id like ur input and tell me the odds of messing up the system.

    heres a picture of what I did. Wrote text in it xplaining whats what.
    [​IMG]

    just a closer look at the connectors:
    [​IMG]

    I used staples to connect the wires together.
     
  2. vnf4ultra

    vnf4ultra TechSpot Paladin Posts: 1,388

    So you're connecting the new case's fp audio connector to the old case's fp audio wire, which fits on the board correctly?
    As long as you got the wires connected to each other properly it should work. How well does it stay together? If they don't stay together well, consider possibly electrical taping the connectors together.
     
  3. truflip

    truflip TS Rookie Topic Starter Posts: 390

    yea the connection between the wires are good. I dont think i will need electrical taping on them but i will jus to make sure. Also.. on the front panel. only the left ear would work. So what i did was, i took two staples and put them both in one slot (of the old wire) then took the left ear and right ear pin (of the new case's wire) and stuck them in as both Left ears. that way theres sound coming out of both side of the headphone.. hmm will this affect the circuits and possibly cause problems?
     
Topic Status:
Not open for further replies.

Similar Topics

Add New Comment

You need to be a member to leave a comment. Join thousands of tech enthusiasts and participate.
TechSpot Account You may also...