Dlink DFE-530TX, driver issue.

Well, I have been up all night trying to get my NIC card to work. Here is the situation:

I just built my new PC, I am using reusing my old NIC card.

The CD with the drivers to it is damaged and will not insall.

I downloaded the drivers (version 6.0 and version 6.1) and burned them to a CD. then copied them to my new computer.

When I attempt to run the setup from thoes I get this:
"Error 1311. Source file not found
C:\Docume~\Mark\Locals~1\Temp\Temporary Directory 2 for
dfe530TX+_drivers_610_.zip\windows\disk2.cab Verify that the file
exists and that you can access it."



If I use device manager auto detect does not find anything; and when I go through and find it and install it I get 'Error 10'



When I installed my Motherboard(X48T-DQ6) software it installed two network adapters 'realtek RTL8168C(P)/8111C(P) PCI-E Gigabit Ethernet NIC" however both are giving me 'network cable unplugged' messages.

(according to Dlink Realtek drivers should work just fine)

Any ideas guys?

after a few calls to dlink i was told it was a microsoft error. I searched the microsoft site and all I got for disk2.cab was about embeded XP, and microsoft office 2003.


anyone know where I can get this file?