Foxconn Mobo not booting up?

B

bobrobr

Hi, My computer is powering up, but does not go through the POST checks. In addition, there is no signal to the monitor. I have changed cables to the monitor but still the same. There initially was regular beeps approximately 3 seconds long continually sounding, but after trying the cables, there is one long beep, then a short beep, then the computer powers down. I would be grateful for any advice on what the problem may be? I believe it may be the onboard graphics that has failed, could this happen? I was going to fit an AGP graphics card that I have spare to check it, but the mobo doesn't take it, only PCI & PCIe.

The mobo is a Foxconn 945GZ7MC-KS2H.

Thanks.
 
Long repeated beeps are a symptom of loose or faulty memory. Remove and re-seat the memory to see if the computer powers up again.
I'm not sure why it's powering down now unless the memory or something else is causing a short.
 
Thanks Sean. I have already tried the memory but I will give it another go, tomorrow though! I'll post again once I've checked it again. Yes, I am worried now that it is powering down by itself?

bobrobr
 

Similar threads

midian182
Redditor creates ungodly gaming PC with 13 internal screens and 15,000 looping GIFs
Replies
9
Views
63
bri kess
B
zohaibahd
SilverStone's 2,500W PSU powers up to four RTX 5080s - or three 5090s - without breaking a sweat
Replies
13
Views
694
user478318
user478318
midian182
Nvidia RTX 5090 graphics card connector melts, but unofficial cable may be the cause
Replies
12
Views
761
CMP01
C

Latest posts

Back