New readings off my main PC

AMD AM2 5600+ X2 @ 3066/Cooler Master Hyper TX/1.4v/32/41

All I did was Clean the dust fliters, and re wire the whole thing, and it knocked a good 6 off idle and 7 off load, getting another fan above the cpu soon, see how much that'll help

On my other PC I got:

Athlon AM2 3800+ @ 2.65 GHZ/Stock cooler off a Athlon AM2 5600+ x2/1.35v/39c/45c

And the only Fans in the PC are the CPU HSF, The graphic card's HSF (stock) and the PSUs fan, so not bad for 3 fans, and no case ones, Im getting 4 case fans in it soon, so see how low I can get the temps, as the CPU wont go any higher, Will test this as soon as I get the replacement Harddrive for it after I killed the old one in it, getting the CPU to 2.69Ghz

Maybe some one here could help me out but my temp dont seem to be reading right with any software i use what the problem. i just took pics of what it was reading at the time but my temp change real fast and i just had new motherboard put in which is a biostar p4m80-m4 with a super i/o chip ite8705 here a link to the thread i made . Problem with everest diagnostics and benchmarking program

AMD 4600+ @ 2.7 GHz / ZALMAN CNPS9700110mm / 1.425 v / 23°C / 40°C

That's only 0.025 v higher than stock with the same HT multipliers and without putting in any memory dividers (on 3GB of RAM underclocked from 800 to 667 MHz); just pushed the fsb up by 25.

AMD 4000+/2.4GHz/Asus ASP5P/Stock/39c-42c@Idle/102F - 106F/
48c - 55c Under load

AMD 5600+@3.15GHz/zalman CP790/1.475v/31-35C/40-43C - B-rad

....E6400 / ArcticFreezerPro7 / stockv /48-50c / 63-65c ........ IDU/Speedfan temps ...................Prime95 for Vista?

Didn't notice an E6550 Conroe yet so....
E6550 @ 2.33ghz/stock/stock/~29c/~36c

Updated with all the information which has been posted in the correct format.

Please do post in the correct format (as mentioned in the first post). I am updating this on my own free time, and I'm not getting too much of it these days to read your posts and format it so everyone else doesn't have to spend 10 minutes figuring it out.

It takes only a minute to do on your part.

I really do appreciate people contributing to this list, and I'm sure there are others who will find such a list helpful.

E6400 @ 3.4GHz/Ultra120eXtreme w/Sunon 120mm @98CFM/1.45v/39C/56C

VCore is set to 1.45V in BIOS but reads at approx.1.425V in all sensor readout programs. It's a satanic ABIT sensors from hell thing. You have to be an ABIT fanboy to understand.

I have run this setup on both the ABIT AB9 and the ABIT IP35 Dark Raider. Pic is with the AB9
Speed step disabled. I run full tilt boogie at all times.
Fan EQ disabled but I do run the CPU fan through a Nexus controller for when I need some quiet time.
MCH @ 1.45V
DDR2 @ 2.3V
I have no AC so in summer heat temps climb. The max I've seen is 65C with ambient room temps over 90F (32C)
I also have Everest Ultimate. I have it on auto start with only the CPU and GPU temps showing in the task bar by the clock. I wish there was a less bloated program to do that with, like MBM5 which no longer works on dual cores. At least not for me even with available work arounds.
Condor don't feel bad. The Intel thermal analysis tool gives me a BSOD (actually the system reboots).

Isn't anyone running any E8000 series Intels here? I'm thinking about getting an E8400 with my stimulus check (gotta do my patriotic duty and save the economy), and I'd love to see some temp specs on the Wolfdale 45's



The truth is in the burn.

5200+@2.7ghz 22 idle 38 at load 1.31v antec 1200 hundred chassis with all the fans + gemini 2 cooler

AMD Opteron 180 @ 3.0GHz/1.475v/34C/43C/Swiftech H20-220

Q9450 Yorkfield @3.5ghz/ stock(voltage)/ThermalTake V1/40C/59C

Intel® Pentium® 4 Processors 3E GHz

E8400@3.6GHz/1.29v/32C/68C/AC Freezer7 Pro - TBolt

@supersmashbrada...
How you likin' that new core, eh?
vvv

core i7 920 @ 4.2Ghz / freezone 120mm fan / 1.47v / 35C / 57C

E6320 @ 2.45GHz / CNPS9500 / 1.5375v / 35C / 43C

I wonder if something is wrong with my CPU. I have to increase the voltage by one notch (0.00625v) every three weeks or so lately just so it'll stay stable.

power supply issue?

E6400@3.69Ghz/Zalman reserator 1(supermodded)/1.5V/12C/22C

Why didn't I think of that?!

Look at what I'm running. Then imagine running that on a 4 year old 460 Watt PSU.

http://img512.imageshack.us/img512/593/56165398gu3.jpg

^ load temps


idle temps are 24 c and lower...

specs are

Intel Q9550 @ 3.7 Ghz|8 GIGS ddr 2 1066 dominator z|ATI 4870 X2 in cross fire|Vista Ultimate x64|
Asus rampage Formula|2 3.0 MB Drives 500 gigs|XFI Xtreme music|Custom Water Cooling kit|Antec 1200 case|Ultra x3 1000 watts|