Built a PC running XP Pro and the only program I am running on it is a Dialer Program and it continues to keep shutting down and giving me the following error message, I have checked the 2Gb DDR2 memory, its fine, and have not tweeked or overclocked the processor! Any Ideas???? Maybe the BIOS is not compatible with the processor?? I am not a real technical computer guy so forgive me if this is a stupid question but any help would be appreciated.
A problem has been detected and windows has been shut down to prevent damage to your computer.
DRIVER_IRQL_NOT_LESS_OR_EQUAL
If this is the first time you’ve seen this stop error screen, restart your computer. If this screen appears again, follow these steps:
Check to make sure any new hardware or software is properly installed. If this is a new installation, ask your hardware or software manufacturer for any windows updates you might need.
If problems continue, disable or remove any newly installed hardware or software. Disable BIOS memory options such as caching or shadowing. If you need to use safe mode to remove or disable components, restart your computer, press F8 to select Advanced Startup Options, and them select safe mode.
Technical Information:
*** STOP: 0x000000D1 (0x00000060, 0x00000002, 0x00000000, 0xF69EA39E)
*** winachcf.sys - Address F69EA39E base at F6922000, Datestamp 3f981493
Beginning dump of physical memory
Physical memory dump complete.
Contact your system administrator or technical support group for further assistance.
A problem has been detected and windows has been shut down to prevent damage to your computer.
DRIVER_IRQL_NOT_LESS_OR_EQUAL
If this is the first time you’ve seen this stop error screen, restart your computer. If this screen appears again, follow these steps:
Check to make sure any new hardware or software is properly installed. If this is a new installation, ask your hardware or software manufacturer for any windows updates you might need.
If problems continue, disable or remove any newly installed hardware or software. Disable BIOS memory options such as caching or shadowing. If you need to use safe mode to remove or disable components, restart your computer, press F8 to select Advanced Startup Options, and them select safe mode.
Technical Information:
*** STOP: 0x000000D1 (0x00000060, 0x00000002, 0x00000000, 0xF69EA39E)
*** winachcf.sys - Address F69EA39E base at F6922000, Datestamp 3f981493
Beginning dump of physical memory
Physical memory dump complete.
Contact your system administrator or technical support group for further assistance.
