T techster Posts: 16 +0 Jun 23, 2010 #1 My PC has a DVD drive. I am trying to add a CD drive. The DVD is set to master. The CD is set to slave. The CD will not work or show up in hardware. If I unplug the DVD the CD works. What's up?
My PC has a DVD drive. I am trying to add a CD drive. The DVD is set to master. The CD is set to slave. The CD will not work or show up in hardware. If I unplug the DVD the CD works. What's up?
mailpup Posts: 7,914 +963 TS Special Forces Jun 23, 2010 #2 Just to be clear, the CD is set to slave by the jumper on the back of it?
T techster Posts: 16 +0 Jun 23, 2010 #4 Yes, the CD is set to slave on the back of unit. All cable connections are OK.
H Hazard Posts: 33 +0 Jun 23, 2010 #5 hmmm i would check out the manual, if you find nothing useful i would check the warranty out as it might be a fault.
hmmm i would check out the manual, if you find nothing useful i would check the warranty out as it might be a fault.
Stellar Blade hits PC on June 11 with modest system requirements
