Spread the love! TechSpot Tech Gift Shortlist 2017

Radeon HD 5870 won't save overscan settings

By ethanajs
Aug 28, 2010
Post New Reply
  1. I have the Overscan/Underscan settings set to 0% on the Overscan side and every time I start up my computer I have to set it again. Any ideas why it won't save this setting?
  2. WoLF36O

    WoLF36O TS Rookie

    you're not alone

    Have the same problem here with HD 5670. overscan issue doesnt appear until drivers and CCC are installed. then the settings arent retained after a reboot :( will keep looking and post back if i find anything
  3. ethanajs

    ethanajs TS Rookie Topic Starter

    Yeah I haven't had much luck figuring it out either yet. But from what I have learned all I have to do is start the control center and click ok to close it, then it goes back to normal. I noticed the bar is at the appropriate setting but it's not actually doing it!

Similar Topics

Add your comment to this article

You need to be a member to leave a comment. Join thousands of tech enthusiasts and participate.
TechSpot Account You may also...