Gentoo, iwconfig, ndiswrapper, plus other problems

I have all sorts of problems tonight. I will begin by explaing my setup as best I can.

Distribution: Gentoo kernel 2.6.27
Wireless Management: wireless-tools & wpa_supplicant (just trying it out) and ndiswrapper 1.53

Hardware:
Target Machine: Inspiron 8200 with a Marvell 8335 Wireless PCMCIA adapter
Network: Netgear MRV814 Router, Speedtouch 330 ADSL modem
ICS Host Machine: Running XP SP3 with Internet Connection Sharing enabled. Obviously, the modem is connected directly to the host computer and the router is just acting as bridge to the ICS gateway.

As a preface, ICS works perfectly fine. I can connect to the internet through my wireless router with no problems. The problem, is that I can not access any MSN services or websites I believe as a result of the MTU setting. So now we continue with some terminal output...

#lspci

03:00.0 Ethernet controller: Marvell Technology Group Ltd. 88w8335 [Libertas] 802.11b/g Wireless (rev 03)
#ndiswrapper -l
Code:
mrv8335 : driver installed
device (11AB:1FAA) present

#ifconfig

wlan0 Link encap:Ethernet HWaddr 08:10:17:02:0d:39
inet addr:192.168.0.194 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::a10:17ff:fe02:d39/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:264 errors:0 dropped:0 overruns:0 frame:0
TX packets:267 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:252933 (247.0 KiB) TX bytes:19569 (19.1 KiB)
Interrupt:11 Memory:f4010000-f4020000

#iwconfig

lo no wireless extensions.

sit0 no wireless extensions.

wlan0 IEEE 802.11b ESSID:"NDAWHOUSE"
Mode:Managed Frequency:2.462 GHz Access Point: 00:09:5B:52:89:42
Bit Rate=11 Mb/s Sensitivity=-200 dBm
RTS thr=2346 B Fragment thr=2346 B
Encryption key:off
Power Management:off
Link Quality:50/100 Signal level:-64 dBm Noise level:-96 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

As you can see, the MTU is currently set to 1500. The optimal MTU for PPOE ADSL connections is 1492. I believe that the host ICS computer is set to 1492; however, I will need to get back to you guys on that one. The current symptoms on the target I8200 machine are as stated, no access to msn services, and a seemingly slower connection over time. I have been googling for some time on changing the MTU with little success.

My current config files that are applicable:

/etc/conf.d/net

-I know this is not set up right at the moment. I'm learning.




# This blank configuration will automatically use DHCP for any net.*
# scripts in /etc/init.d. To create a more complete configuration,
# please review /etc/conf.d/net.example and save your configuration
# in /etc/conf.d/net (this file :]!).

##################
#Ethernet Config
##################

config_eth0=( "null" )

##################
#Wireless Config
##################

config_wlan0=( "192.168.0.2/24" )
routes_wlan0=( "default via 192.168.0.1" )
essid_wlan0="NDAWHOUSE"
config_NDAWHOUSE=( "192.168.0.1/24 brd 192.168.0.255" )
routes_NDAWHOUSE=( "default via 192.168.0.1" )
dns_servers_NDAWHOUSE=( "192.168.0.1" )

##################
#WPA Supplicant
##################

modules=( "wpa_supplicant" )
wpa_supplicant_wlan0="-Dndiswrapper"

# It's important that we tell wpa_supplicant which driver we should
# be using as it's not very good at guessing yet
/etc/wpa_supplicant/wpa_supplicant.conf

Code:
# This is a network block that connects to any unsecured access point.
# We give it a low priority so any defined blocks are preferred.
# The below line not be changed otherwise we refuse to work
ctrl_interface=/var/run/wpa_supplicant

# Ensure that only root can read the WPA configuration
ctrl_interface_group=0

# Let wpa_supplicant take care of scanning and AP selection
ap_scan=1

# Simple case: WPA-PSK, PSK as an ASCII passphrase, allow all valid ciphers
network={
ssid="NDAWHOUSE"
scan_ssid=1
#proto=WPA
#pairwise=TKIP
#key_mgmt=WPA-PSK
#psk="pw"
# The higher the priority the sooner we are matched
priority=5
}

These are the only applicable config files I know of for a wireless connection. I orginally thought it may be my Marvell driver as the chipset has a bad reputation, but I have installed Ubuntu on this machine with the same exact ICS setup without problems. All msn websites and messenger worked fine. I cannot verify the MTU setting on my Ubuntu install, as Gentoo has since replaced it. Thus, I am convinced the problem lies in this configuration, as the rest of the network has not changed.

I have probably forgotten something, so let me know and I'll post more information. I wrote this in a hurry. Anyway, does anyone know how to change the MTU setting on a Gentoo install as outlined above?

Thanks in advance

disable IPv6
inet6 addr: fe80::a10:17ff:fe02:d39/64 Scope:Link

I had thought of that, but it is not actually the offending setting.

For the benefit of any folks that may google it in the future, I'm going to mark this solved, although I wish I had a more detailed evaluation of the specific setting in question.

I was using kernel 2.6.27 vanilla that I had compiled myself. Downloading the new kernel 2.6.27.6 and recompiling has fixed the problem. I did not make any significant changes to the networking config portion of menuconfig.

I'll try to do a more in depth analysis of the difference between my previous kernel config and the present one.

>>dns_servers_NDAWHOUSE=( "192.168.0.1" )

usually there are TWO dns addresses, but this setting should work;
can you resolve names to addresses, eg
nslookup www.google.com?

you might find the true DNS from your ISP and substitue them. the default route
will cause the request to be forwarded as necessary.