Corsair SandForce 240GB SSD Firmware 5.05a
Here is the 5.05a firmware update for 22** series SandForce based drives. This includes the Force 3, Force GT, Force GS, and the GB2B and GB2B R/F series only.
Important Notes Before Updating:
If you are stable and do not have issues, we suggest that you do not flash your firmware.
This update is intended to not be destructive. However, we strongly urge that you back up any important data before beginning this procedure.
Be sure to download the correct update file for your drive. Many complaints we have seen were the result of downloading the wrong file for your drive.
This update has been validated for use with Windows 7. It has not been validated with Windows Vista and Windows XP however it may work with these OS's. Users are encouraged to update the drives with Windows 7 when possible.
This update tool is intended to be run with the drive controller in AHCI mode. If your drive controller is not AHCI enabled and your update fails, you will need to change it to AHCI mode and also enable AHCI in your OS registry. Here is page with a guide for ENABLING AHCI.
If you have issues updating using the Microsoft AHCI driver, you may need to update using the latest driver from your drive controller manufacturer. The reverse is also true. If you have issues updating using the latest drivers from your controller manufacturer, we suggest you try the latest MS AHCI driver.
Our latest testing is only with Intel and AMD drive controllers. The update may not work with 3rd party drive controllers. The update will not work on a controller that is in RAID mode. This applies to SATA2 and SATA3 controllers.
DO NOT at any time power off your system during this procedure. This may “brick” your drive.
After your update if you still have issues, we strongly recommend the following steps:
- Complete clearing of the BIOS. This is a good idea after any firmware flash of any device.
- Secure erase the SSD. For some users, cloning of the drive works, for others it does not. This may be dependent upon the cloning tool used.
- A clean installation of the OS if you experience instability after a BIOS clearing and secure erase.
UPDATE YOUR BIOS. As always for users with issues, we recommend that you update your motherboard/notebook to the most recent BIOS before attempting to flash your firmware. This may or may not resolve your issue but it is an excellent first step. Quite a few boards/notebooks have been given SSD specific updates over the past few months.
Ignore any terms in the firmware file name relating to Micron, Intel, etc. This has no bearing on the upgrade. You need only match the SIGNATURE as noted in the .PDF file.
Be sure to download the correct version for your drive. We have had people complaining that our files are wrong only to find that they downloaded the wrong file.
Note: The PDF is labeled as the 1.3.3 version but you can ignore this. The procedure is the same for the 5.05a update.
Note: Before proceeding with your driver installation we suggest you make sure you are installing the latest version available and for the appropriate model/revision and Operating System. We strongly suggest following 'readme' instructions for installing drivers when available. Often restarting your system will be necessary for the new driver to become active and start functioning properly.
Downloads and Drivers
Subscribe to TechSpot
Receive a weekly update of our best features and tech news you don't want to miss: