|
Audio Performance
-
Signal-to-Noise Ratio with AES17
filter (A-Weighted)
|
|
|
|
|
|
|
|
|
|
|
|
Center, Subwoofer and
Rear Center
|
|
|
-
Total Harmonic Distortion + Noise at
1kHz (AES17) = 0.004% (1V, 2V Rated Output)
-
Frequency Response (+/-3dB,
24-bit/96kHz input ) = <10Hz to 46kHz (1V, 2V Rated
Output)
High Definition Audio Quality for
Playback and Recording
-
24-bit Digital-to-Analog conversion
during playback with sampling rates of 8, 11.025, 16,
22.05, 24, 32, 44.1, 48 and 96kHz in 7.1 mode and up to
192kHz in stereo mode
-
24-bit Analog to Digital conversion
during recording in 8, 16 or 24-bit at sampling rates of
8, 11.025, 16, 22.05, 24, 32, 44.1, 48 and 96kHz
-
SPDIF (Sony/Philips Digital
Interface) input at up to 24-bit/ 96kHz quality
-
SPDIF output up to 24-bit at 48 or
96kHz
-
ASIO 2.0 drivers for low latency (as
low as 2ms) multi-track playback and recording at
16-bit/48kHz or 24-bit/96kHz
Wave-Table Synthesis and Midi
Features
-
Creative Hardware synthesizer (2x16
Channels) with 64-voice polyphony featuring E-MU®'s
patented 8-point interpolation technology for accurate
sample reproduction
-
Creative Software synthesizer -
multi timbral wave-table (16 Channels)
-
2 MIDI I/O ports (2x16 channels) (gameport
adapter required for MIDI I/O 2)
FireWire® (IEEE®1394) Connectivity
Sound Blaster Audigy 2 ZS Platinum
Pro On-Board Connectors
-
Line level out (Front / Side / Rear
/ Center / Subwoofer)
-
Digital CD Audio in
-
Aux Audio in
-
AD_LINK 1 and AD_LINK 2 Connectors
-
Power Connector
-
15-pin MIDI/ Joystick port extension
header
Sound Blaster Audigy 2 ZS Platinum
Pro External I/O Hub Front/Rear Panel Connectors
-
Headphone Out (1/4" Stereo Jack)
-
Line In 1 (1/4" Stereo Jack , shared
with Microphone In with Gain Control)
-
Line In 2 (1/4" Stereo Jack)
-
Line In 3 (2x RCA Jack)
-
Optical SPDIF In/Out
-
Coaxial SPDIF In/Out
-
Digital Out for 5.1 support
(6-channel SPDIF Output to Creative digital speakers)
-
2x FireWire® (IEEE®1394) ports
-
MIDI In / Out
-
Infra-red Receiver
-
AD_LINK 1 and AD_LINK 2 connectors
|