Dual Boot with Raid 0 and non-raid disk

Status
Not open for further replies.
Hello All

I have 2 500Gb SATA Seagate disks in a Raid 0 (stripe) configuration running VISTA. Was running like this for a while and then installed another 250Gb SATA Seagate drive.

My raid controller recognized this disk as a non-raid disk and I could see it was using port 2 on my raid controller (port 0 and 1 were being used by the 500Gb disks). I then preceeded to install XP on the non-raid disk (had to use F6 to install raid software while doing this install). Xp installed fine and I can access the RAID-0 disk while in XP. The problem is I cannot boot into VISTA again.

I tried playing with BOOT.ini but cant get it to recognise the RAID-0 disk as bootable. Please help!
 
Status
Not open for further replies.
Back