BSOD problem on new computer

By pelo911
Apr 24, 2010
  1. intel core i3 530
    gigabyte H55m-UD2H
    ocz gold 1600mhz 8-8-8-24 1.65V
    WD black 500gb
    Cooler Master 500W PSU

    those parts i take from the old system:
    old IDE DVD burner
    old CASE , 80mm fan on the back of the case (without front 120mm fan that enter cold air to the case or side fan)

    i tried to install windows 7 32bit instead of the 64bit
    but the problem stays.

    Problem signature:
    Problem Event Name: BlueScreen
    OS Version: 6.1.7600.
    Locale ID: 1033

    Additional information about the problem:
    BCCode: a
    BCP1: 0000011C
    BCP2: 00000002
    BCP3: 00000000
    BCP4: 82A4614B
    OS Version: 6_1_7600
    Service Pack: 0_0
    Product: 256_1

    Probably caused by : ntkrnlpa.exe ( nt+3814b )

    what can i do to solve this problem?
    it's happend sometimes 4 time in one hour and sometime one time a day.


    Attached Files:

  2. pelo911

    pelo911 TS Rookie Topic Starter

    when the Blue screen appear , there is way to read it before the restart after 2 seconds?
  3. Route44

    Route44 TechSpot Ambassador Posts: 11,984   +72

    Your error is 0xA and one of the causes for this error code is hardware. In your case it specifically cited memory corruption as your cause. Your symptoms bear this out.

    So, you will need to run the completely safe and free memtest on your RAM.

    See the link below and follow the instructions. There is a newer version than what is listed but either one should work. If you need to see what the Memtest screen looks like go to reply #21. The third screen is the Memtest screen.

    Let it run for a LONG time. The rule is a minimum of 7 Passes; the more Passes after 7 so much the better. There are 8 individual tests per Pass. Many people will start this test before going to bed and check it the next day.

    If you have errors you have corrupted memory and it needs to be replaced.

    Also, with errors you need to run this test per stick of RAM. Take out one and run the test. Then take that one out and put the other in and run the test. If you start getting errors before 7 Passes you know that stick is corrupted and you don’t need to run the test any further on that stick.


    * Get back to us with the results.
Topic Status:
Not open for further replies.

Similar Topics

Add your comment to this article

You need to be a member to leave a comment. Join thousands of tech enthusiasts and participate.
TechSpot Account You may also...