Re-Installing Raid drives after a crash

By Bamoman
Dec 27, 2008
  1. i had a puter set up on a raid with 2x320gig HDs setup as raid what happened is my MB pooped out on me and i had to replace it....i replaced it with the same MB i had in hopes that i could just throw my raid configed drives right in and it work? well it didnt......i did not mark the drives so i would know which one plugged in where....SO my question is can the info on the 2 320gig drives be recovered buy installing them back in the puter using raid 0 and how would i do that?

    Thanks in advance :)

  2. gavinseabrook

    gavinseabrook TS Rookie Posts: 320

    When using raid, you need to be sure to place the drives in the location they were in prior to removal. One thing you can do is go into the raid bios utility/raid setup and look at the status on the drives. Usually it will give you more info about why its not connecting.
Topic Status:
Not open for further replies.

Similar Topics

Add your comment to this article

You need to be a member to leave a comment. Join thousands of tech enthusiasts and participate.
TechSpot Account You may also...