Hi all,
My problem is after that I changed from an old CRT display to Packard Bell Viseo 193ws, i can't access BIOS anymore. When i turn my computer on, all i see is "input not supported".
After my Windows XP has started up, then I see the picture, and it works normally.
Now my hard disk is failing, (i have another) but i can't install windows because i cant see what im doing.
My video card is radeon 9600 PRO, mother board is ASUS A7V400-MX.
I have tried many different display drivers, Omega and ATI, but the problem stays.
The settings are ok, 1440 x 900 / 60 Hz (I can't even change the refresh rate, changing resolution does not help either).
I have googled for hours, but i just can't find any solution. If someone has any ideas they are very appreciated.
cliffs: no signal in BIOS, after OS loads, everything works fine.
Thanks in advance!
My problem is after that I changed from an old CRT display to Packard Bell Viseo 193ws, i can't access BIOS anymore. When i turn my computer on, all i see is "input not supported".
After my Windows XP has started up, then I see the picture, and it works normally.
Now my hard disk is failing, (i have another) but i can't install windows because i cant see what im doing.
My video card is radeon 9600 PRO, mother board is ASUS A7V400-MX.
I have tried many different display drivers, Omega and ATI, but the problem stays.
The settings are ok, 1440 x 900 / 60 Hz (I can't even change the refresh rate, changing resolution does not help either).
I have googled for hours, but i just can't find any solution. If someone has any ideas they are very appreciated.
cliffs: no signal in BIOS, after OS loads, everything works fine.
Thanks in advance!
