fattygiant
Posts: 12 +0
My laptop is using XP Pro. and setup network connection but can not access the internet. So i tried to repair the connextion but i go a message of: TCP/Ip not enable...
what should ido?
what should ido?
TCP/IP not enable.
- Thread starter fattygiant
- Start date
- Status
Samstoned
Posts: 1,009 +0
check you nic tcp/ip properties
right click on connection left click properties
highlight tcp/ip go to properties should show conection if a network setup should have manual setup of DNS WAN
and IP address's
otherwise should be dynamic
go back to desktop
click start run enter cmd
type ping type in a ip address that you know
on a network do search lots of places have guides for your router
right click on connection left click properties
highlight tcp/ip go to properties should show conection if a network setup should have manual setup of DNS WAN
and IP address's
otherwise should be dynamic
go back to desktop
click start run enter cmd
type ping type in a ip address that you know
on a network do search lots of places have guides for your router
D
DelJo63
You didn't mention how you're connected (dial-up,cable,dsl) nor if other systems
are attached, but there are four things needed for all tcp connections
ipconfig /all
Normally allowing Get IP and DNS dynamically works well, just make sure any other
configuration data is removed.
are attached, but there are four things needed for all tcp connections
IP address,
IP mask,
DNS address.
Gateway address
you can / should see all of these with the commandIP mask,
DNS address.
Gateway address
ipconfig /all
Normally allowing Get IP and DNS dynamically works well, just make sure any other
configuration data is removed.
- Status
