Do NOT upgrade firmware on any D-Link product over a wireless connection.
Failure of the device may result. Use only hard-wired network connections.

What's New:

Problem Resolved:
- Fixed: Can't edit the public community.
- Modified TX power table for 8200 according the table from PM
- Modified to support new Israel.
- No matter the SSID broadcast is enabled or disabled, the AP in WDS (WDS+AP as well) mode with WPA-PSK/WPA2-PSK should work properly(WDS can't connect when user disabled SSID Broadcast).
- Task dead(failed reboot,after apply setting) when change apmode from WDS to AP by D-View.
- User cann't get wdsclient info at each side,when reboot device on both side at the same time.
- When multi-state enable,and set ssid like "%*",ap will reboot continually.
- [WEB]"Domain Name" in DHCP,which set by AP Manager v1.20 can not display to the Web page.
- The Korea domain should not support turbo mode in 11g band.

Enhancements:
- WMM support for each SSID.
- RADIUS Accounting for each SSID.
- support SSID broadcast “enable/disable” for each SSID
- add Output power control for Korea.
- SMTP support in log setting.
- Configuration file extension from CFG to DCF.
- Change default SSID to “dlink”.
- Add command “get/set SNMP” to control snmp state.
- add 3 get power commands for MFG, they are “getswpower/controlpower/targetpower”
- Add fw upgrade protection policy.
- Support 64Bytes username length for radius authentication.
- Support 64 character WEB login username length.
- support Character Set of WEB login username,include "a~z","A~Z","0~9","@", ".", "-" and "_".
- Pop error message when key in unsupported characters in WEB login user name
- Add Telnet command “Get PassPhrase” to display passphrase of wpa-psk
- Add Telnet command “Get RadiusSecret” to display Radius Secret
- add character filter for SSID,0x20~0x7F(ASCII) set is supported.
- remove character filter for SSID setting.
- Modify the Korea channel to [36, 40, 44, 48, 52, 56, 60, 64, 100, 104, 108, 112, 116, 120, 124, 149, 153, 157, 161]